-2--1-
1.INTRODUCTION
NOTE
This meter has been designed and tested according
to CE Safety Requirements for Electronic Measuring
Apparatus, EN 61010-1, EN 61010-2-32 and other
safety standards. Follow all warnings to ensure safe
operation.
WARNING
READ "SAFETY NOTES" (NEXT PAGE) BEFORE
USING THE METER.
2.SAFETY NOTES
Read the following safety information carefully before
attempting to operate or service the meter.
l Use the meter only as specified in this manual,
otherwise the protection provided by the meter
may be impaired.
l Always keep hands behind the meter barrier.
l Use extreme caution when clamping around
uninstalled conductors or bus bars.
l Never clamp around any conductor carrying a
voltage above 600V R.M.S.
l Rated environmental conditions
1. Indoor use.
2. Installation Category III.
3. Pollution degree II.
4. Altitude up to 2000 Meter.
5. Relative Humidity 80% Max.
6. Ambient Temperature 0~40°C.
l Observe the international Electrical Symbols listed
below
Alternating current.
Earth (ground) terminal.
Meter protected throughout by double
insulation or reinforced insulation.
Caution ! Refer to this manual before
using the meter.
Warning ! Risk of electric shock.
To Next Page
Loading...