Shandong New Beiyang Information Technology Co. BTP-3200E User Manual (English)

Questions and Answers:

T
Travis SandovalJul 31, 2025
What to do if my Shandong New Beiyang Information Technology Co. BTP-3200E says 'Paper end'?
- B
  Brittany JonesJul 31, 2025
  If the Shandong New Beiyang Information Technology Co. Label Maker shows a 'Paper end' error, several factors could be responsible. It may be that the paper roll is used up or not installed, so install a new paper roll. Alternatively, there might be a paper jam, which needs to be cleared. The paper roll surface could be dirty or damaged, in which case you should skip the affected part. It's also possible that the paper roll has detached from the mark sensor, requiring reinstallation. A dirty mark sensor surface should be cleaned. If the reflective sensor is incorrectly positioned, adjust its position as described in section 3.5. Finally, ensure that the paper type selected in the printer driver matches the actual paper type.
M
Mary Gray MDAug 4, 2025
Why is the printout from my Shandong New Beiyang Information Technology Co. BTP-3200E Label Maker unclear or stained?
- S
  Sarah PerryAug 4, 2025
  If the printout from your Shandong New Beiyang Information Technology Co. Label Maker is unclear or has stains, it could be due to several reasons. First, the print head or platen roller might be dirty, so try cleaning them. Second, the paper you're using might not meet the necessary requirements; switch to recommended paper. Third, the print darkness setting could be too low, so increase it. Finally, the paper might not be installed correctly; make sure to install the paper roll properly.
D
daliAug 9, 2025
What to do if my Shandong New Beiyang Information Technology Co. BTP-3200E Label Maker says 'Lack of ribbon'?
- B
  Blake MillerAug 9, 2025
  If your Shandong New Beiyang Information Technology Co. Label Maker indicates a lack of ribbon, the ribbon may be used up, so install a new ribbon. Alternatively, the ribbon may be jammed, in which case you should clear the jam. A failure of the ribbon sensor can also cause this problem, so replace the ribbon sensor.
J
Jared VelezAug 12, 2025
Why does my Shandong New Beiyang Information Technology Co. BTP-3200E Label Maker say 'Print head temperature abnormal'?
- V
  victor85Aug 13, 2025
  If your Shandong New Beiyang Information Technology Co. Label Maker shows that the print head temperature is abnormal, it is likely that the operating environment is too hot, causing the print head to overheat. To resolve this, improve ventilation. The printer should return to normal once the temperature decreases.
N
Nicholas CoxAug 17, 2025
What causes mark location failure on Shandong New Beiyang Information Technology Co. Label Maker?
- R
  rjacksonAug 17, 2025
  If you encounter mark location failure or mark calibration failure with your Shandong New Beiyang Information Technology Co. Label Maker, it could be due to a mismatch between the paper type and the sensor type. Set the paper type in the printer driver to match the actual paper type. Alternatively, there might be an issue with the marked paper itself, such as missing or unclear marks; use the required media.
V
Vincent WrightAug 21, 2025
How to fix 'Print head up' error on Shandong New Beiyang Information Technology Co. Label Maker?
- H
  Holly GomezAug 21, 2025
  If the print head of your Shandong New Beiyang Information Technology Co. Label Maker is up, it could be due to two reasons. First, the print head might simply be lifted up; please press down the print head. Second, the micro switch might have a failure; in this case, contact the maintainer.