Your helmet is supplied with a visor. This visor
is part of the helmet, and the helmet must not
be used if the visor is in poor condition.
Before using your helmet for the first time,
remove the protective plastic film from the
visor. Check that the visor is clean and does
not have scratches that could make it fragile
or alter your vision in any way. During the life
of the helmet, use only visors and spare parts
supplied by Shark.
A
Check the attachment of the visor on the
helmet to be sure the visor will not fall off while
you use the helmet.
1. Open and close the shield completely. Repeat
several times to check the motion of the visor
mechanism.
2. With the visor wide open, slide your fingers
between the visor and the helmet, and pull to
check that the visor remains well secured to
the helmet. However, do not pull excessively or
stretch the visor.
B
Installing and removing the visor must
always be done carefully. Do not force the visor.
If you do not know how to properly remove or
install the visor, please contact your retailer.
C
Tinted or dark visors should never be used
at night or under poor visibility conditions as
they reduce your ability to see. Never ride with
a fogged visor.
REMOVE THE VISOR
To Next Page
Loading...
