Why is my Shark VAC-THEN-STEAM MV2010WM Vacuum Cleaner not picking up dirt?
Your Shark Vac-Then-Steam might not be picking up dirt due to a few reasons. First, check the filters to see if they require cleaning; follow the instructions for rinsing and drying them before putting them back in. Also, the dust cup might be full, so empty it. Finally, inspect the nozzle at the cleaning base for any blockages and clear them if necessary.
What to do if my Shark VAC-THEN-STEAM MV2010WM won't turn on?
Ensure your Shark Vac-Then-Steam is securely plugged into a 120V AC electrical outlet. Check your fuse or breaker. Switch the Steam or Vacuum Power button to the ON position.
Why is my Shark VAC-THEN-STEAM MV2010WM Vacuum Cleaner hard to push?
If your Shark Vac-Then-Steam is hard to push, make sure the steam pad is attached correctly. Check to see if your pad is excessively dirty and replace the pad if it is too dirty or wet. Try increasing the height of the pole for better leverage by raising the telescopic latch.
What to do if Shark VAC-THEN-STEAM MV2010WM leaves water on the floor?
If your Shark Vac-Then-Steam is leaving water on the floor, check to see if your micro-fiber cleaning pocket has absorbed too much moisture. If so, unplug the Vac-Then-Steam and replace the micro-fiber cleaning pad. Make sure the steam pocket is attached correctly. Wait 30 seconds after switching the Steam Power button ON to heat water to sanitizing 212° steam; if the unit is not allowed to heat properly, some water may be emitted.
How to make my Shark VAC-THEN-STEAM MV2010WM Vacuum Cleaner produce steam?
To ensure your Shark Vac-Then-Steam produces steam, make sure the water tank is filled to the indicated fill line. Attach the Steam Pad and Frame to the base of the unit and switch the Steam Power button to the ON position. Tilt the mop to generate steam.
General| Brand | Shark |
|---|---|
| Model | VAC-THEN-STEAM MV2010WM |
| Category | Vacuum Cleaner |
| Language | English |
Caution regarding hot steam emitted from the appliance.
Instructions for assembling the Shark Vac-Then-Steam unit.
Overview of the dual operating modes of the cleaning system.
Details on operating the vacuum function of the cleaning system.
Instructions for operating the steam cleaning function.
Guidance on washing and maintaining the reusable cleaning pads.
Instructions for rinsing and drying the foam filter.
Steps for cleaning and replacing the post-motor filter.
To Next Page