02
Above ground pools are not designed to be installed below ground level. Outside ground forces can collapse pool wall.
If you have an irregular terrain, contact your dealer for approppriate advice. Pools installed on irregular terrain ARE
NOT COVERED BY THE MANUFACTURER WARRANTY.
Be careful
Mark out the area
Drive a peg/stake into the ground at the center of the area where you want your pool.
Use a length of str
ing ed between the peg and a can of spray can, and mark a circle
on the ground (a tape measure can also be used). The circle will be 12” (30 cm)
bigger all around than the pool. (image 1) See radius length below.
Pool diameter
15’ (4,5m)
18’ (5,5m)
21’ (6,4m)
24’ (7,3m)
Radius
8’ (2,4m)
9’6’’ (2,9m)
11’ (3,3m)
12’6’’ (3,8m)
Pool diameter
27’ (8,2m)
30’ (9,1m)
33’ (10m)
Radius
14’ (4,3m)
15’6’’ (4,8m)
17’ (5,2m)
Remove the sod
Remove all sod and plants from the circle. (image 2)
Remove any s
cks, stones and roots from the circle using rake.
To make sure your pool is stable, compact the ground well with the compactor,
before adding the sand.
IMPORTANT NOTE:
Your pool must be perfectly level. Take the
me you
need to be sure your founda
on is perfectly level.
GROUND PREPARATION
To Next Page
Loading...
