Sharp 20F640 XFlat - Page 24

24
24
Dimension: 140mm x 215mm
Parental Control (V-CHIP Operation Continued)
L Turning On (Activating) the V-Chip Blocks
1 Repeat steps 1 to 3 of [1] MPAA RATING.
2 Press to access V-CHIP BLOCK select mode, then
press to move the “a” mark to “SECRET No.”.
3 Enter a 4-digit SECRET No. using the REMOTE KEYPAD .
4 Press to move the “a” mark to “STATUS”,
then press to activate the V-CHIP BLOCK. (If STATUS
is OFF, V-CHIP BLOCK will not operate.)
5 When done, press MENU to exit.
L To cancel the V-CHIP BLOCK screen while V-CHIP BLOCK has been activated.
1 “V-CHIP HAS BEEN ACTIVATED” will be displayed if you view a
program containing Program Rating data as same as you
configured.
Note:
• “V-CHIP HAS BEEN ACTIVATED” will not be displayed if STATUS is
not configured to “ON”.
2 Press MENU , then “INPUT SECRET No.” will be displayed.
3 Enter the 4-digit SECRET No. using the REMOTE KEYPAD , then
V-CHIP BLOCK temporarily will be canceled. If the wrong SECRET
No. is chosen, “SECRET No. IS INCORRECT” will be displayed.
Input the SECRET No. again in this case.
Note:
• If you turn the power from OFF, the V-CHIP BLOCK will automatically reset to ON again.
V – CH I P OCKLB
MPAA
TV UGI
OP OINT
DEL I NES
SEC ERT ––No .
STA UTSO:FF
: ––
(V-CHIP BLOCK select mode)
CH
8
9
CH
;
:
VOL
–
VOL
+
V – CH I P OCKLB
MPAA
TV UGI
OP OINT
DEL I NES
SEC ERT 34No .
STA UTSO:FF
:12
;
:
VOL
–
VOL
+
→
CH
8
9
CH
MENU
→
321
654
987
0
V – CH I P OCKLB
MPAA
TV UGI
OP OINT
DEL I NES
SEC ERT 34No .
STA UTSO:FF
:12
MENU
23
V – CIHP
AC VIAETDT
HAS BEEN
TV– Y7
FV
INP TUS
––––
EECR T oN.
INP TUSEECR T oN.
∗∗∗∗
321
654
987
0
CH a/s
VOL k/l
CH a/s
VOL k/l
20F640