Sharp Aquos LC 20S4U - MANUAL CLOCK Setting; Time Display

16
Setting the CLOCK (Continued)
TIME DISPLAY
You can display the current time on the screen.
Repeat steps 1 to 3 of MANUAL CLOCK Setting on
this page.
Press '/" to select “TIME DISPLAY”, and press
ENTER.
SET
TIME DISPLAY ON
OFF
Press '/" to select “ON” or “OFF”, and press
ENTER.
Press MENU to exit.
A
• When you press DISPLAY, the current time is displayed for about
10 seconds.
Selected item Description
ON Displays the current time on the screen.
OFF No display
1
MANUAL CLOCK Setting
If there are no channels with EDS signals, set the clock
manually using MANUAL CLOCK.
Press MENU to display the Menu screen.
Press \/| to select “SETUP”.
Press '/" to select “CLOCK”, and press ENTER.
SETUP OPTION
CH– SETTING
MTS
CLOCK
INPUT3 SELECT
V – CHIP BLOCK
CLOSED CAPTION
COLOR SYSTEM
LANGUAGE
Press '/" to select “SET”, and press ENTER.
Press '/" to select “MANUAL”, and press ENTER.
SET
TIME DISPLAY AUTO
MANUAL
Press '/" to select “DST”, and press \/| to select
“ON” or “OFF”.
Press '/" to select “TIME”, and press \/| to set the
time, and press ENTER.
12:00AM 11:59AM
11:59PM 12:00PM
• Holding down \/| changes the setting at a high speed.
SET
TIME DISPLAY DST OFF
TIME 12: AM
00
Press MENU to exit.
A
• Make sure to press ENTER after adjusting the time. Otherwise,
the time will not be set.
• When DST is set to “ON”, the time entered is forwarded by 1 hour.
• Please be sure to set “DST” before setting “TIME”.
3
Daylight Saving Time (DST) Adjustment
The Daylight Saving-Time changes as shown below, set the
DST to “ON” to forward the clock by 1 hour. To rewind the
clock by 1 hour, set the DST to “OFF”.
(Spring)
On the first Sunday in April DST starts.
(Autumn)
On the last Sunday in October DST finishes.
1:00AM 2:00AM
3:00AM 4:00AM
Advances 1 hour.
1:00AM 2:00AM
1:00AM 2:00AM
Rewinds 1 hour.
1
4
5
6
2
3
4
2
LC-20S4U_E_P14-20.p65 04.12.8, 6:26 PM16