- 33 -
■ Precautions when using the product in a bathroom
•
Do not let the product submerged into or get wet with hot water of a bathtub
or hot spring or water containing soap, detergent or bath powder.
Doing so might cause a fault.
If liquid other than tap water is attached on the product, you fall the product
into the bathtub, etc., immediately rinse the product in the specific procedure
and drain water or dry the product naturally.
•
Use the product within 2 hours continuously in a bathroom where the range
of a temperature is 40°C or less, a humidity is 99% or less.
After that, be sure to drain water or dry the product naturally in the specific
procedure.
All function's continuous operations are not completely guaranteed.
•
Take care not to get the product wet with high temperature water.
•
The rapid changes of temperature may cause condensation.
Wait until the product reaches room temperature before you bring it from a
cold place into a warm bathroom etc.
Also, do not get the warmed product wet with cold water in a bathroom.
Doing so might cause water intrusion or a fault.
•
If condensation occurs inside the camera lens or display, leave it in room
temperature until the condensation is removed.
•
Do not use the product connected to an earphone/microphone or external
device in a bathroom.
•
Do not charge the product in a bathroom.
•
Set “glove mode” to OFF in a bathroom.
On the home screen → “App list screen” → [Settings] → [Display] →
[Advanced] → [glove mode] to change the setting.
To Next Page
Loading...
Need help?
General
