Sharp AR-M550N - Page 270

: Feb. 9 2004
1
AR-M550/M620/M700 SIMULATION 8 - 12
26 18 Used to set YES/NO of toner save
operation. (This function is valid only
in Japan and UK versions. (Depends
on the destination setting of SIM26-
6.) For the other destinations, the
same setting can be made by the
user program P22.)
Setting Specifications Operation
mode
30 Used to set the operation mode
conforming to the CE mark (Europe
safety standards). (Conforming to
soft start when driving the fusing
heater lamp.)
Setting Specifications Operation
mode
(Common)
35 Used to set whether the same
continuous troubles are displayed as
one trouble or the series of troubles
with SIM 22-4 when the same
troubles occur continuously.
Setting Specifications
38
Used to set CONTINUE/STOP of
printing when maintenance timing is
over and the count value reaches
110% of replacement timing (life).
Setting Other Specifications
41 Used to set YES/NO of the
automatic magnification ratio
selection (AMS) in the pamphlet
mode.
Setting Specifications Operation
mode
(Common)
50 Black-White reverse YES/NO setting Setting Specifications Operation
52 Used to set whether non-print paper
(insertion paper, cover paper) (blank
image print paper) is counted up or
not.
Setting Paper transport
(Discharge/
Switchback/
Transport)
Specifications Operation
mode
68 Used to set ENABLE/DISABLE of
the CA key cancel function of print
stop.
Setting Specifications Operation
27 1 Used to set the specifications for
operations in case of communication
trouble between the host computer
and MODEM (machine side). (When
communication trouble occurs
between the host computer MODEM
and the machine, the self diag
display (U7-00) is printed and setting
for inhibition of print or not is made.)
Setting Communication
unit (TEL/LIU/
MODEM etc.)
Specifications Operation
mode
5 Used to enter the machine tag No.
(This function allows to check the tag
No. of the machine with the host
computer.)
Setting Communication
unit (TEL/LIU/
MODEM etc.)
Specifications Operation
mode
30 1 Used to check the operation of
sensors and detectors in other than
the paper feed section and the
operations of the related circuits.
Operation test/Check Operation
2 Used to check the operation of
sensors and detectors in the paper
feed section and the related circuits.
Operation test/Check Paper feed Operation
40 1 Used to check the operation of the
manual feed tray paper size detector
and the related circuit. (The
operation of the manual feed tray
paper size detector can be
monitored with the LCD display.)
Operation test/Check Paper feed Operation
2 Used to adjust the manual paper
feed tray paper width detector
detection level.
Adjustment Paper feed Operation
7 Used to enter the manual paper feed
tray paper width adjustment value.
Adjustment/Setup Paper feed Operation
Code
Function (Purpose) Purpose Section Item
Main Sub
1