20
BEFORE USING THE MACHINE
Bypass tray
1
Open the bypass tray.
If you are loading paper of length greater than 250 mm
(9-27/32"), open the extension tray.
Do not place heavy objects on the bypass tray or press down on the tray.
2
Push the centre of the pressure plate
down until it locks into place.
3
Load the paper with the print side
facing down.
Insert the paper along the bypass tray guides all the way into
the bypass tray until it stops slowly. Inserting the paper with
excessive force may cause the leading edge to fold back.
Inserting the paper too loosely may cause skewed feeding
or misfeeds.
The paper must not exceed the maximum number of sheets.
4
Set the bypass tray guides correctly to
the width of the paper.
Adjust the bypass tray guides so that they slightly contact
the loaded paper.
To Next Page
Loading...
