Sharp EL-2630L User Manual

OPERATING CONTROLS
© ED POWER SWITCH
• GT 1C •
PRINT/GRAND TOTAL/ITEM COUNT MODE SELECTOR:
This selector turns print mode, grand total mode and item count mode
on or off. Mode combinations are as follows:
', cnr fi , 1 1 Note: Numbers are not printed on the calculator.
t ■ 2 j3 j 4 I S] r
*— 1 — 1 - PRINT
1
2
3
4
5
PRINT
OFF
OFF
ON
ON
ON
GT
OFF
ON
ON
OFF
OFF
1C
OFF
OFF
ON
ON
OFF
“PRINT" is on:
“PRINT" is off:
“GT" is on
“GT" is off:
“1C" is on:
“1C” is off:
Note:
Set to the print mode.
(“• ••...••• +P" will be printed.)
Set to the non-print mode.
(“• ••...••• -P" will be printed.)
This selector will accumulate the following:
(“* + " will be printed.)
1. Addition and subtraction totals obtained with [T~l .
2. Product and quotient totals obtained with [JC] or
1 - = ■
3. A nswers obtained with | %~| or |MUj .
Neutral
For addition or subtraction, each time 1 ± 1 is pressed,
1 is added to the item counter, and each time EH is
pressed, 1 is subtracted.
• The count is printed when the calculated result is
obtained.
• Pressing of [T] , []xJ or GO clears the counter.
Neutral
The counter has a maximum capacity of 3 digits (up to +999)
If the count exceeds the maximum, the counter will recoun
from zero.
Set selector to ”5'’ to print results of basic calculations, set selector tc
“1” if results are not to be printed.
3

Sharp EL-2630L Specifications

General

Brand	Sharp
Model	EL-2630L
Category	Calculator
Language	English