LC-32/40/46LE700E/RU/S,LU700E/S,LX700E/RU,LC-52LE700E/RU/S
5 – 18
6. When all the procedures are complete, the following upgrade success screen shows up.
The new software version can be confirmed on screen.
The version number appears when each item has been successfully upgraded. Finally the main version number appears on screen.
7. Turn off the AC power (Unplug the AC power cord). Take out the upgrading USB flash memory.
It takes about 20 seconds until the AC power supply is turned off, perfectly.
8. Now the software has been upgraded.
NOTE: Then get the set started and call the process adjustment screen 1/17 to check the main software version.
CAUTION:
1) Do not take out and put in the USB flash memory during formatting.
2) It takes about one minute to the rewriting completion.
Please confirm the upgrade status on the screen becomes 100%.
LE700
MAIN
SUB MICON
PANEL EEPROM
MAIN Versiin
SUB MICON Version
PANEL EEPROM
Software Update
UPGRADE SUCCESS
1.00
1.00
NO DATA
100%
100%
NO DATA
To Next Page
Loading...
