Page - 18 -
Choose the point „SAT-Symbolrate 1“ and change the symbol rate over the
digit keyboard of the remote control, as shown on the following image.
If necessary carry out the same action with regard to „SAT-symbol rate 2“.
You can find the right value for symbol rates in the Internet at the website of
the relevant satellite operator or the program provider.
Important: You can pre-program 2 symbol rates per one search run. In
case on the satellite more symbol rates are available, by using the point of
menu "Additional search" you can carry out many additional searches with
further 2 symbol rates each, till all symbol rates are found.
To Next Page
Loading...
