Sharp MD-MT15

Notes:
© ‘When making important recordings, itis
recommended that you use the AC
adapior. A fully charged rechargeable
battery or alkaline batteries should be
loaded into the unit. Then, even if a
power failure occurs, the power source
will witch over to the battery automati-
cally.
‘© When using the rechargeable battery or
the alkaline batteries, i the volume level
is setto 0", the battery consumption wil
'be less than when listening to the re-
‘cording while itis being made.
€@ Insert each plug firmly the connections
‘are poor, the recording may not be made
properly.
Always
keep
the
plugs
clean.
{tthe plugs are diy, electrical noise may
be recorded.
‘Thore are two types of discs: playback-only
‘and recordable discs,
© Playback-only MiniDisc:
‘This type of MiniDise usually contains
commercially available pre-recorded
‘musi, This i the samo kind of optical
disc as CDs. Playback s performed us-
ing an optical pickup.
(Flecording and edting are not possible.)
‘There will only
be a shutter on
‘one side (the back).
@ Recordable MiniDisc:
This is a “raw disc” on which recording
can be performed.
Ths is a magneto-optical ais.
Recordings are made using a laser and
‘a modulated magnetic field. Repeated
recording is possible.
Shutters can be
{| seen on both
sides of this
type of disc.
To prevent recorded discs from
Being erased accidentally
Slide the accidental erase prevention tab,
located on the side of the disc, in the direc:
tion indicated by the arrow.
© The disc will then be protected against
‘accidental erasure.
(© To.add a recording to such a disc, side
the accidental erase prevention tab back
1o its original positon.
RECORDING USING THE ANALOG CABLE
Recording from CDs or MDs
¢ recording)
‘Synchro
recording
is
a
method
that
detects
the
playback
sound
from
the
source
equip-
‘ment.
When
sound
is
present,
i
automat
cally
stats
the
recording.
When
the
source
Is
silont,
the
recording
will
be
paused.
4 nie playing sound from the extemal
‘equipment connected to this unit, press
the Hed ort button to adjust the re-
cording level
LINE
1 Connect the extemal equipment.
(See page 8)
2 inser a recordable MiniDisc
®
3 Press the REC bution.
(© 70 record trom a tuner, fist tune in a
broadcast.
{© To record irom a CD, first start play-
ng the track you want to record.
10
‘© Adjust the recording level so that the
‘maximum sound volume from the
source makes the reading swing
‘somewhere between ~4 JB and 0.dB,
{© To record from a CD, first adjust the
recording level. Then put the equip:
ment connected to this unit into the
playback stand-by mode,
'5 Press the ENTER/SYNC button.
=e
Fiashing —aon
os ong
6 Begin playback on the source equip:
‘mont
{@ Recording will begin automatically.
To interrupt recording:
© When the source equipments stopped,
the unit will enter the synchro recording
stand-by mode. When playback is re
sumed, a recording will be resumed.
€@ ‘asiience lasts for 3 seconds or more,
the recording will be paused.
‘© Pressing the mit bution on this unit
(when in this mode) will cause the uni
1 enter the recording stand-by mod
‘and cancel the synchro recording mod
(© The track number will be increased by
fone each time the recording is inter-
rupted.
To stop recording:
Press the mV:OFF button.
@ it the unit is left unattended after the
recording is complete, the power will
‘aulomatically shut off in approximately
2 minutes.