Sharp MX-3071 Troubleshooting

12
General Problems
Is the detection range set correctly? ■ Adjust the detection range.
PRINTING IS NOT POSSIBLE OR STOPS DURING
A JOB
Check Solution
Is a tray out of paper? ■ Add paper as instructed by the message in the touch panel.
Is the machine out of toner? ■ Replace the toner cartridge.
► Maintenance (page 6)
Has a paper misfeed occurred? ■ Remove the misfeed as instructed by the message in the touch panel.
Is the output tray full? ■ Remove the output from the tray and resume printing.
When the output tray becomes full, a detector activates and stops printing.
Is the waste toner box full? ■ Replace the waste toner box as instructed by the message in the touch panel.
Are restrictions placed on the trays
that can be used in each mode (copy,
print, image send, and document
filing)?
■ Check the settings in [Paper Tray Settings] and see if checkmarks appear in the
checkboxes of each mode ([Feeding Approved Job]).
Functions without a checkmark cannot be used for printing using that tray.
 "Settings" → [System Settings] → [Common Settings] → [Paper Settings] →
[Paper Tray Settings] → [Tray Registration] → [Feeding Approved Job]
Check Solution
!
Motion sensor
Near Far
?
!

Sharp MX-3071 Specifications

General

Print Technology	Laser
Print Resolution	1200 x 1200 dpi
Duplex Printing	Yes
Scan Resolution	600 x 600 dpi
Memory	5 GB
Hard Disk Drive	500 GB
Functions	Print, Copy, Scan, Fax
Max Copying Resolution	600 x 600 dpi
Duplex Copying	Yes
Scanning Color	Yes
Duplex Scanning	Yes
Standard Paper Capacity	650 sheets
Print Speed	30 ppm
Connectivity	USB, Ethernet
Type	Multifunction
Copy Speed	30 cpm
Automatic Document Feeder (ADF)	100 sheets
Operating System Compatibility	Windows, Mac, Linux
Max Paper Capacity	6300 sheets