20
General Problems
THE FINISHER/SADDLE FINISHER DOES NOT
OPERATE
Check Solution
Does a message appear indicating
that you need to remove paper from
the stapler compiler?
■ Remove all remaining paper from the stapler compiler.
Have functions been disabled by the
administrator?
■ Check with your administrator.
Some functions may have been disabled in the setting mode.
STAPLING DOES NOT TAKE PLACE (INCLUDING
SADDLE STITCH)
Check Solution
Does a message appear instructing
you to check the staple unit?
■ Remove jammed staples.
► Maintenance (page 6)
Does a message appear instructing
you to add staples?
■ Replace the staple cartridge.
Do not forget to replace the staple case.
► Maintenance (page 6)
Is a different width of paper mixed in? ■ To perform mixed size stapling, using paper of the same width and select the
[Same Width] setting.
Stapling is not possible when paper of different widths are mixed together. When
copying, select [Same Width] for [Mixed Size Original] in [Others].
Are there more sheets than can be
stapled at once?
■ For the maximum number of sheets that can be stapled, see "SPECIFICATIONS"
in Start Guide.
Is a paper size that cannot be stapled
included in the print job?
■ For paper sizes that can be stapled, see "SPECIFICATIONS" in Start Guide.
Is the paper type setting of the tray
selected in the printer driver set to a
paper type that cannot be stapled?
■ You must check the paper types that are set on the machine, and select a paper
tray that is set to paper* that can be used for staple printing.
Click the [Tray Status] button in [Paper Source] tab of the printer properties
window and check the paper type setting of each tray.
*Stapling is not possible on labels, tab paper, glossy paper, transparency film, or
envelopes. In addition, if "Disable Staple" is selected in the user type, stapling will
not be possible.
To Next Page
Loading...
