Sharp OPTONICA SM-1616H - Service Procedures and Voltage Setting; Unit Disassembly Instructions; Mains Voltage Selection Guide

DISASSEMBLY (See Figure 3)
HOW TO REMOVE THE CABINET:
Remove the 8 screws(1) retaining the cabinet (4 screws each
for the both plates) and take out the cabinet.
HOW TO REMOVE THE FRONT PANEL:
Draw out the 12 knobs @) from the front panel and remove
the 4 screws (3) retaining the front panel.
Then pull the front panel toward you to remove it.
HOW TO REMOVE THE BOTTOM PLATE:
Turn over the set, remove the 2 screws (4) retaining the bottom
plate and lift up the bottom plate to remove it.
Figure 3
MAINS VOLTAGE SELECTION (See Figure 4)
Check the preset voltage before connecting the mains plug
to a mains outlet. If the setting is different from your local
supply mains voltage, the selector must be reset as follows.
Rotate the voltage selector by using a screwdriver so that
your local voltage number can be seen.
SCREWDRIVER
Figure 4