24 | Page
will not be displayed, only the order from the first instruction will
be displayed. When using DSP command, the same following blank
applies to the display.
• You cannot treat a character as data or enter it into
memory. Again, characters cannot be mixed, or characters
cannot be mixed or calculated.
THESE WILL GENERATE AN ERROR:
• “ SIN 30 ” => A
• “ A ” + “ B “ ,
• “ ,
However, “ “ is allowed as it uses the to separate the
statement from other statements. Both the and -,- are used to
separate statements.
• GTO -F- “ A -F- “