Sharp R-1880LST - Page 39

39
R-1880LS/LST
SPECIAL SERVICING NOTE
There is couple of non-replaceable parts attached to the Turn Table & Fan motor. They are called “Spark
Quenchers” and are attached to prevent noise emitted by the Turn Table Motor and Fan Motor from interfer
-
ing with the Sensor operation. If not used on this design, it is possible (in some cases) the Sensor will “Error”
immediately.
(This is a non-replaceable part)
There is a Spark Quencher
attached to the Fan Motor as
shown in
(Fig. S1)
(Fig. S1)
There is a Spark Quencher
attached to the Turn Table
Motor as shown in
(Fig. S2)
(Fig. S2)