Sharp R-8R51 - Page 37

wad
4.
Reinstall
outer
case
and
check
for
microwave
leakage
around
the
door
with
an
approved
micro-
wave
survey
meter.
(Refer
to
Microwave
Measure
ment
Procedure.)
Figure C-7. Door Assembly Replacement
and Adjustment
CHOKE COVER REMOVAL
1,
2;
Insert an iron plate(thickness of about 0.5mm) or
flat type screw driver to the gap between the choke
cover and door panel as shown figure to free the
engagind part.
Lift up the choke cover, now cover is free.
DOOR PARTS REMOVAL
Remove the door assembly, referring to from item 1
through item 4 of "DOOR REPLACEMENT”.
a
a
3.
Place
the
door
assembly
on
a
soft
cloth
with
facing
Up.
Remove
the
choke
cover,
referring
to
“CHOKE
COVER
REMOVAL”.
Remove
the
three
(3)
screws
holding
the
door
sash
right
to
the
door
panel
assembly.
DOOR
SASH
REMOVAL
Pull
the
middle
part
of
the
door
sash
right
and
re-
lease
the
lower
tab
of
the
door
sash
right
from
the
door
frame.
Release
the
upper
tab
of
the
door
sash
right
from
the
door
frame.
Now,
the
door
sash
right
is
free.
DOOR
GLASS
REMOVAL
35
R 8RS1(W}
R 8R51(B)
6. Slide the door glass to the right side until stopped
by door frame. ,
7. Slide the door glass up until stopped by the door
frame.
8. Release the lower part of the door gjass from the
door frame at first, and then release the upper part
of the door glass from the door frame. Now, the
door glass is free.
DOOR FRAME REMOVAL
9. Remove the nine (9) screws holding the door
frame to the door panel.
10. Release the door frame from the door panel, now
the door frame ts free.
LATCH HEAD REMOVAL
11. Release the latch spring from the tabs of the door
panel.
12. Release the latch spring from the tatch head.
13. Release the latch head from the door panel.
14. Naw, the latch head is free.
FLAT TYPE
SCREW-DRIVER
PROTECT BY TAPE
FLAT TYPE
SCREW-DRIVER
enone] Fecon
COVER PANEL
‘4
Figure C-8. Choke Cover Removal