CVP09FX
3 – 8
40.Unscrew 4 screws holding the motor cover and wire holder.
Remove the motor cover.
Then remove the fan motor.
41.Unscrew the screw holding the centrifugal fan.
42.Unscrew 5 screws holding the motor cover and wire holder.
Remove the motor cover.
Then remove the fan motor.
43.Remove the 2 motor cushions on each side.
44.Loosen 2 screws holding the motor cover B.
* Do not remove 2 screws and 2 nuts.
45.Remove the motor cover A.
46.Slide and remove motor cover B, C and D, as shown in below fig-
ure.
To Next Page
Loading...
