Canceling the ice making mode
Use this feature during night time or winter time.•
You can use the ice storage box as a freezer case.•
To cancel operation
1
Select ice making mode which is in operation.
2
Select “OFF”.
3
Finalize the setting.
4
Empty the water tank.
Dry it thoroughly and set into the original position.
After canceling the ice making
Even after canceling the set ice making mode, it will •
conduct once the ice releasing operation, therefore the ice
tray and the detection lever will operate.
After nishing the ice releasing operation, ice making •
process indication will turn off.
Do not put any food until the ice making process indication •
turns off. Otherwise, it may break the detection lever.
To start operation again
Refer to “Ice making”.
Ice tray cleaning
You can clean the ice tray and the pipe.
Use this feature at the beginning or when the refrigerator
has not been used for a long time.
The water is supplied from the water tank to the ice tray •
forcibly.
The water discharge amount at one cleaning will be 100mL.•
However, when large ice mode is set as on, the water
discharge will be 230mL.
Preparation
Pour water into the water tank and set into the original
position. Empty the ice storage box.
To start operation
1
Select ice tray cleaning icon.
2
Select “ON”.
3
Finalize the setting. (Ice tray cleaning will start.)
During ice tray cleaning operation
It takes about 40 sec.
Do not pull out the ice storage box.
The process indication will toggle like in the
above picture.
4
Follow steps
2
to
3
again.
5
Finally push button. Empty the water of the ice
storage box.
Dry it thoroughly and set into the original position.
NOTE
Once it completes cleaning, it returns to the ice making
operation that it is currently set at.
To Next Page
Loading...
Need help?
General
