14
3 Replacement of brake block (Figure 11, 12):
a. Refer to Step a to e on P.14 on motor dismantling.
b. Refer to Step b to g on P.13 on replacement of speed change belt to dismantle the upper belt
housing.
c. Remove the spindle pulley off.
d. Use flat head screw driver to kick-off the two half piece of brake shoe (A).
e. Remove the two springs (B).
f. Press the assembled brake shoe to rear support pin (C) first, then to the front cam (D).
g. For new brake shoe, some adjustment is required.
To Next Page
Loading...
