37
(b) Zero Positioning (as shown in Figure 23) of Dial Ring of Table Feed.
1. Loosen the nut (D) of dial ring.
2. Turn the dial right (E) to zero position.
3. Lock the nut (D) of dial ring.
(c) Setting of Sliding Surfaces of Work Table, Saddle and Knee:
All non-feed sliding Surfaces shall be secured and set to prevent slipping and increase
machine body's rigidity. The sliding surface setting levers (as shown in Figure 24) are
clockwise for setting and counterclockwise for release.
To Next Page
Loading...
