Item No. 204050
SOUND SOOTHER WHITE NOISE MACHINE
Quick Start Guide
SETTING THE TIME
SETTING ALARM 1
SELECTING YOUR WAKEUP NATURE SOUND
1. Press and hold CLK / MEM button for 2 seconds. The
digits will begin to flash.
2. Press <<HR to adjust the hours.
3. Press >>MIN to adjust the minutes.
4. When you have set the clock to the correct time, stop
pressing the buttons. The display will flash 3-4 times
and then save automatically.
NOTE: The hours and minutes advance forward only.
Also, if your desired time is PM, be sure to keep
advancing the << HR button until the PM indicator light
is illuminated.
1. Press and hold ALM1 VOL+ button for 2-3 seconds.
The digits will begin to flash.
2. Press <<HR to adjust the hours.
3. Press >>MIN to adjust the minutes.
4. When you have set the alarm to your desired time, stop
pressing the buttons. The display will flash 3-4 times
and then save automatically. The alarm sound (Buzzer,
Radio or Nature Sound) will be indicated by a red LED
dot.
5. To change the alarm sound (or turn the alarm off),
press ALM1 VOL+ to cycle through the 4 alarm sound
options: Buzzer / Radio / Nature Sound / Alarm Off.
1. You may choose any of the 20 Nature Sounds to be your
wakeup sound.
2. Follow the steps above to set the time for Alarm 1.
3. Set the alarm sound to N.S. (Nature Sound) by pressing
ALM1 VOL+.
4. Press ALM1 VOL+ for 3 seconds. WHILE THE DISPLAY
IS FLASHING, press the Natural Sound Select button
repeatedly to cycle through the Nature Sounds from 1
to 20. You may also select “NA” to wake up to samples
of all the Nature Sounds in a row (approximately 10
seconds each).
- 1 -
CLK/MEM
ALSO “NATURAL
SOUND SELECT”
<< HR
>> MIN
DIMMER
ALM2
VOL -
ALM1
VOL +
ALM OFF/SOURCE
SNOOZE/SLEEP
To Next Page
Need help?
General
