09P is set start options for start up method, 00→zero start, 01→non-zero start.
10P is set options for drive mode.
00→ Power-assisted drive only, 01→ Electric drive only, 02→ Power-assisted drive and electric drive coexist.
(05P is shown in the picture)
Assist gear range setting interface
(06P is shown in the picture)
Wheel diameter setting interface
(08P is shown in the picture)
Speed limit setting interface
(09P is shown in the picture)
Startup mode setting interface
(10P is shown in the picture)
Assist mode setting interface
To Next Page
Loading...
