Only replace the fuse(s) in the SR-8100 with a fuse(s) of proper value and voltage rating.
The SR-8100 should only be cleaned as directed in the manual. Avoid spraying liquids directly onto the
SR-8100 and NEVER spray liquids into the vents. Care should be taken so that small objects do not
fall into the inside of the SR-8100.
You should seek service for your SR-8100 by qualied service personnel if any of the following occur:
1. The power-supply cord or the plug has been damaged.
2. Objects or liquid have fallen or spilled into the vents.
3. The SR-8100 has been exposed to rain.
4. The SR-8100 exhibits a marked change in performance.
5. The SR-8100 has been dropped, or its enclosure or chassis is damaged.
NOTE: TO COMPLETELY DISCONNECT THE SR-8100 FROM THE AC POWER MAINS,
DISCONNECT THE AC POWER CORD FROM THE AC RECEPTACLE.
NOTE: THE SR-8100 AC POWER CORD MUST REMAIN READILY ACCESSIBLE AT ALL TIMES.
!
CAUTION
CAUTION: TO REDUCE THE RISK
OF ELECTRICAL SHOCK, DO
NOT REMOVE COVER. NO USER
SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
Antenna lead-in wire
Grounding conductors
(NEC section 810-20)
Antenna discharge unit
(NEC section 810-20)
Power service grounding
electrode system
(NEC art 250, part H)
Ground clamps
Ground clamp
Electric service
equipment
NEC - National Electrical Code
To Next Page