4.9 User Setting
Mobile DaRt Operation Manual
4-43
The buzzer is set to “on” at the time of delivery of the apparatus.
If no more settings are required, press the registration switch
to register the
set contents.
Then,
is indicated on the X-ray control panel, and the operation
returns to the normal mode.
4.9.8 Setting collimator lamp control ( )
The setting is indicated on mAs indicator.
Pressing mA [+] or mA [-] switch varies the indication of setting as follows:
⇔ ⇔ ⇔ ⇔ ⇔ ⇔
Table4-9 Content of collimator lamp setting
Indication on the
hundreds place of mAs
Content
After the preparation for exposures has finished, the
collimator lamp lights for approximately 10 seconds.
The collimator lamp comes off when the preparation for
exposures starts. (When the collimator lamp is to be turned
on, stop the Ready operation and then put on the collimator
lamp.)
The preparation for exposures starts while the collimator
lamp is lighting. Once the collimator lamp shuts off, and just
after the preparation has finished, the collimator lamp lights
for approximately 10 seconds.
Indication on the ones
place of mAs
Content of collimator lamp setting
Enables collimator lamp turned on/off by the click operation
of the hand switch.
Disables collimator lamp turned on/off by the click operation
of the hand switch.
The indication is set to “ ” at the time of delivery of the apparatus.
If no more settings are required, press the registration switch to register the
set contents.
Then, is indicated on the X-ray control panel, and the operation returns
to the normal mode.
To Next Page
Loading...
Need help?
General
