EasyManua.ls Logo

Shimano Steps EW-SW100 - Replacing the Charging Port Cap; Charging of the Satellite System ON;OFF Switch

Shimano Steps EW-SW100
57 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
52
Maintenance
Replacing the charging port cap
Replacing the charging port cap
For models: EW-CP100
1. Remove the charging port cap.
2. Replace with a new charging port cap.
As shown in the figure, push it in with your fingers.
Charging of the satellite system ON/OFF
switch
For models: EW-SW100, EW-SW300
The power does not turn ON if the built-in battery of the satellite system ON/OFF switch is not
adequately charged. Follow one of the methods below to charge it. It takes a maximum of two
hours to charge the built-in battery.
Charge the built-in battery while the (main) battery is mounted on the bicycle. (BM-E6000 /
BM-E6010 / EW-CP100 only)
When the (main) battery is fully charged, charging of the built-in battery of the satellite
system ON/OFF switch also stops automatically.

Other manuals for Shimano Steps EW-SW100

Related product manuals