5
TO ENSURE SAFETY
TO ENSURE SAFETY
DANGER
Be sure to also inform users of the following:
Handling the battery
• Do not deform, modify, disassemble, or apply solder directly to the battery. Doing so may
cause leakage, overheating, bursting, or ignition.
• Do not leave the battery near sources of heat such as heaters, and do not heat the
battery or throw it into a fire. Doing so may cause bursting or ignition.
• Do not throw or subject the battery to strong shock. Doing otherwise may cause it to
overheat, burst, or ignite.
• Do not place the battery into fresh water or sea water, and do not allow the battery
terminals to get wet. Doing otherwise may cause it to overheat, burst, or ignite.
• When charging the specified battery, use the specified battery charger for charging and
observe the specified charging conditions. Doing otherwise may cause overheating,
bursting, or ignition.
WARNING
• Be sure to follow the instructions provided in the manuals when installing the product.
Only use SHIMANO genuine parts. If a component or replacement part is incorrectly
assembled or adjusted, it can lead to component failure and cause the rider to lose
control and crash.
•
Wear approved eye protection while performing maintenance tasks such as
replacing components.
• For information on products not explained in this manual, refer to the manuals for each
product.
Be sure to also inform users of the following:
• Do not to pay excessive attention to the cycle computer display while riding. Doing so
may result in an accident.
• Check that the wheels are fastened securely before riding the bicycle. You may fall and
be seriously injured.
• Be sufficiently familiar with how to start the power assisted bicycle before riding on busy
streets. You may start the bicycle unexpectedly, which may result in an accident.
To Next Page
Loading...