Need help?Do you have a question about the Shindaiwa DGW400DM-C and is the answer not in the manual?
Overview of the owner's manual and its purpose for safe operation.
Explains the symbols and terms used for Danger, Caution, and notes.
Detailed safety precautions and hazard warnings for equipment operation.
Key technical data including model, generating method, and output ratings.
Descriptions of Eco welding, CV/CC modes, and remote control capability.
Explanation of digital meters and monitor lamps on the control panel.
Details on Earth Leakage Relay and Slow-Down Feature for safe operation.
Procedure for adjusting the AC output voltage for different loads.
Steps for checking engine oil, coolant, and fuel before starting.
Procedures for starting, restarting after fuel loss, and stopping the engine.
Guidelines for selecting welding cables, polarity, and connections.
Information on stick welding, wire feeder use, and duty cycle.
Details on generator ratings and available output receptacles.
Guidelines for using welding and generator functions concurrently.
Periodic checks and maintenance tasks based on operating hours.
Procedures for long-term storage and troubleshooting common issues.
General| Rated Voltage | 230 V |
|---|---|
| Frequency | 50 Hz |
| Electrode Diameter | 2.0 mm |
| Run Time at 50% Load | 10 hours |
| Welding Current Range | 40 - 400 A |
To Next Page
