To Next PageTo Next PageWhat to do if Shizuoka Seiki VAL6 KBE1S does not ignite?
If the Shizuoka Seiki Heater doesn't ignite, first ensure the fuel tank has an adequate amount of fuel. If the tank is full, check for water contamination and replace with fresh, clean fuel if necessary. Additionally, a clogged fuel filter element or nozzle could be the culprit; inspect the filter element and replace if clogged.
Why Shizuoka Seiki Heater does not start but the lamp is lit?
If the Shizuoka Seiki Heater does not start and the lamp is lit, it is likely that the safety devices are activated. Ensure that the flame monitor isn't exposed to any light, such as sunlight or electric lamps, and reposition the heater to prevent direct light from reaching the radiation disk.
What to do if flame goes out during the operation of Shizuoka Seiki Heater?
If the flame goes out during operation of your Shizuoka Seiki Heater, the fuel might be contaminated. You should clean the fuel tank and replenish it with fresh fuel. Also, a dirty flame monitor can cause this issue, so clean the flame monitor. Lastly, a clogged fuel filter element might be the cause, so inspect it and replace if necessary.
General| Model | VAL6 KBE1S |
|---|---|
| Category | Heater |
| Type | Kerosene Heater |
| Fuel | Kerosene |
| Fuel Tank Capacity | 5.5 L |
| Power Source | Electric |
Details components related to operation control.
Details components of the burner assembly.
Steps and precautions before operating the heater.
Procedures for daily checks and maintenance.
Check and clean the fuel tank's inlet filter.
Check fuel filter and drain water from the fuel tank.
Steps to replace a blown fuse.
Procedure for replacing the fuel nozzle.
Electrical schematic of the heater.
