Need help?Do you have a question about the SHOEI QWEST and is the answer not in the manual?
General| Retention System | Double D-ring |
|---|---|
| Sizes | XS-XXL |
| Shield System | CW-1 shield |
| Interior | 3D comfort liner system, removable and washable |
| Safety Certification | DOT, Snell M2010 |
| Category | Full-Face |
| Shell Material | Fiberglass composite |
| Pinlock | Pinlock-ready |
Description of the lower air intake vent and its function.
System for preventing visor condensation using airflow.
Description of the upper air intake vent and its function.
Refers to the main outer part of the helmet.
The internal liner designed to absorb impact energy.
Description of the rear GT top exhaust vent.
Improves visor/window beading contact when fully closed via base plate.
SHOEI's mechanism to prevent visor fogging using airflow.
Locks the shield/visor to prevent accidental opening during rides or falls.
Step-by-step guide to unlock and remove the shield/visor from hook rails.
Instructions for inserting hooks into rails and securing the shield/visor.
Ensure close contact after cleaning/replacement; adjust base plate to eliminate gaps.
Use correct screwdriver size and genuine parts; avoid over-tightening screws.
Never ride with a fogged shield; use ventilation or preset opening to prevent fogging.
Information on Pinlock® lens performance and care for preventing fogging.
Prevents wind and noise rolling in around the chin area.
Step-by-step guide for installing and removing the chin curtain.
Instructions for inserting the Breath Guard into the gap between shell and liner.
Identification of removable parts like cheek pads and chinstrap covers.
Guidance on selecting the correct size for helmet inner parts.
Table detailing pad sizes for different helmet sizes (ECE R22 & SNELL).
Steps to unsnap and remove cheek pads and their plate portions.
Procedure to remove the chinstrap cover after removing the cheek pad.
Instructions for fitting the chinstrap cover onto the strap and snapping it.
Guide to correctly fitting cheek pads, ensuring snaps are aligned.
Handle parts near snaps carefully; press snaps firmly until they click.
Washing instructions for parts, using neutral detergent and avoiding harsh cleaners.
Ensure shield/visor gears and hooks are locked before riding.
Cleaning instructions using mild cleaners; avoid solvents and abrasives.
Confirm cheek pads and chinstrap covers are properly equipped before use.
To Next Page
