Shopsmith MARK V 510 - Router Table Safety Rules

Page 3
522155 MARK V MODEL 505/510 ROUTER TABLE
long hair under a hat.
• Avoid dangerous environments. Don't use
power tools in damp, wet, or explosive
atmospheres.
• Keep works area well lit, clean, and free
from clutter.
• Do not force the tool. It will do the job
better and safer at the rate for which it was
designed.
• Use the right tool. Do not force a tool or
accessory to do a job for which it was not
designed.
• For directional feed, ALWAYS feed the
workpiece into the cutter against the rota-
tion of the cutter. NEVER feed the
workpiece into the cutter with the rota-
tion of the cutter.
• Check for damaged parts. A damaged
guard or part must be properly repaired
or replaced before further use of the tool.
If a strange noise or vibration develops,
immediately turn off the power, unplug
the machine and correct the problem.
Never operate a power tool that is not
functioning properly.
• Secure workpieces. Use clamps, fixtures
and other devices to hold workpieces
when practical. It's safer than using your
hands and frees your hands to operate
the tool.
• Do not overreach. Keep proper footing
and balance at all times.
• Turn off the tool and wait until it comes to
a complete stop before removing
workpieces and scraps.
• Do not try to stop the tool by grabbing the
workpiece or any part of the tools. Turn
off the tool and let it come to a complete
stop by itself.
• Do not leave the tool running unattended.
Turn off the power. Don't leave the tool
until it comes to a complete stop.
• Avoid unintentional starting. Make sure
the switch is in the "off" position before
plugging in or unplugging the tool.
• Disconnect tools. Turn off and unplug
tools before changing accessories, setups,
making adjustments, performing main-
tenance, or repairs.
• Do not stand or lean on the tool. You
could fall into the tool or it could tip over
injuring you and/or the tool.
• Maintain tools. Keep parts and tools sharp,
clean, and maintained according to the
instruction manual.
• Make your workshop child proof. Use
padlocks, master switches and remove
starter keys.
• Keep children away. All visitors must
stay a safe distance from power tools, and
wear ear and eye protection.
• Do not permit anyone who is inexperi-
enced to use your power tools without
proper supervision.
MARK V MODEL 505/510MARK V MODEL 505/510
MARK V MODEL 505/510MARK V MODEL 505/510
MARK V MODEL 505/510
RR
RR
R
OUTER OUTER
OUTER OUTER
OUTER
TT
TT
T
ABLE SAFETYABLE SAFETY
ABLE SAFETYABLE SAFETY
ABLE SAFETY
RULESRULES
RULESRULES
RULES
• Be sure to read and understand this en-
tire instruction manual before using the
MARK V Model 505/510 Router Table.
Also, do not use the MARK V Model 505/