Operation is subject to the following two conditions: (1) this device may not cause harmful interference
and (2) this device must accept any interference that may cause undesired operation of the device.
This device has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communication. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•Consult the dealer or an experienced radio/TV technician for help.
Changes or modications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment. FCC ID: 2AHWR-SS07
CE MARKING & EUROPEAN UNION COMPLIANCE
DECLARATION OF CONFORMITY
Shot Scope declares that this device complies with the essential requirements and relevant provisions of
Directive RED 2014/53/EU.
Go to www.shotscope.com/doc to view the Declaration of Conformity.
Shot Scope Technologies Ltd
Unit 27, Castlebrae Business Centre, 40 Peffer Place, Edinburgh, EH16 4BB,
United Kingdom
MODE, FREQUENCY AND POWER
SOFTWARE LICENSE AGREEMENT
BY USING THE DEVICE, YOU AGREE TO BE BOUND BY THE TERMS OF THE FOLLOWING SOFTWARE
LICENSE AGREEMENT. PLEASE READ THIS AGREEMENT CAREFULLY. Shot Scope Technologies Ltd
grant you the user a limited license to use the software embedded in this device (the “Software”) in binary
executable form in the normal operation of the device & product. Title, ownership rights, and intellectual
property rights in and to the Software remain with Shot Scope Technologies Ltd. You acknowledge
that the software is the property of Shot Scope Technologies Ltd and is protected under international
copyright treaties. You further acknowledge that the structure, organization, and code of the software, for
which source code is not provided, are valuable trade secrets of Shot Scope Technologies Ltd. You agree
not to decompile, disassemble, modify, reverse assemble, reverse engineer, or reduce to human readable
form the software or any part thereof or create any derivative works based on the software.
Go to www.shotscope.com/legal/ for the latest terms and conditions, returns and
privacy policies.
Products intended for sale within the European
Union are marked with a (CE) mark which
indicates compliance to applicable directives
and European norms (EN) as follows.
Products intended for sale within the United
Kingdom are marked with a (UKCA) mark
which indicates compliance to applicable
directives.
To Next Page
Loading...
Need help?
General
