E N
Nome file:
7528001 - ISTRUZIONI WP - IT-EN-ES-FR-DE-NL-ES Rev. 0 05/10/2015
30-102
Fig. 50
•
Support and its location.
If the product is used with a filter, the latter must be downstream from the product.
Fig. 51
If the product is placed outside it is advisable to put a simple cover to protect it from rain.
Make sure the product is positioned in a place where noise generated during normal operations does not
create disturbances.
The product must run in a horizontal position. Make sure its position is not altered once it is correctly
placed.
Fig. 52
The product must be fixed on a firm base, with screws of 6 [mm] diameter, through the prepared holes in
the foot.
Fig. 53
The product must be positioned in a shady and aerated place.
5.6 Connections and start-up.
The electrical system must meet current international and/or national regulations.
The product must be connected to an power outlet equipped with a residual current device with
sensitivity over 30 [mA]. Before starting the product make sure this device is installed in your electrical
system. Contact a technician if necessary.
3
.
5
m
1
3
8
i
n
IN
IN
OUT
M6
M6
1
1
2
m
m
To Next Page
Loading...