What to do if one or more Show Tec Light Fixtures are completely dead?
If your Show Tec Light Fixture is completely dead, ensure that the power is switched on and the cables are securely plugged in. Also, check if the primary fuse has blown and replace it if necessary.
What to do if Show Tec Infinity iW-1915 RGBW Wash Light Fixture has no response to DMX?
If your Show Tec Light Fixture isn't responding to DMX, verify the DMX settings to ensure the addresses are correct. Also, check the DMX cable by unplugging the unit, replacing the cable, and then reconnecting the power. To identify the source of the problem, test the controller with other DMX products. If the controller isn't working, have it repaired. If the controller works, take the DMX cable and the light fixture to a qualified technician.
How to fix Show Tec Infinity iW-1915 RGBW Wash Light Fixture with no light?
If your Show Tec Light Fixture has no light, first try resetting the device to its original factory default settings. Check that the unit is properly plugged into an appropriate power supply. Replace the fuse. If all seems okay, try plugging the unit in again. If the issue persists, return the device to your Show Tec dealer.
Why does my Show Tec Light Fixture have no light or lamp cuts out intermittently?
If your Show Tec Light Fixture is too hot, allow the fixture to cool. Clean the fan and ensure that the air vents at the control panel and front lens are not blocked. You can also turn up the air conditioning. If the LEDs are damaged, disconnect the fixture and return it to your dealer. If the power supply settings do not match local AC voltage and frequency, disconnect the fixture and correct the settings.
General| LED Source | 19 x 15W RGBW LEDs |
|---|---|
| Pan | 540° |
| Tilt | 270° |
| Power Supply | 100-240V AC, 50/60Hz |
| IP Rating | IP20 |
| Type | LED Wash |
| Control | DMX512, Master/Slave |
Covers safety, operating limits, rigging, return procedure, and claims.
Details stand-alone, Master/Slave, DMX control, fixture linking, and data cabling.
Explains the control panel, addressing, and menu overview.
Detailed breakdown of 34 advanced and 14 basic DMX channels.
Covers fuse/battery replacement and common troubleshooting steps.
Essential safety warnings for device operation and handling.
Crucial guidelines for safe operation and handling of the device.
Precautions regarding environment, servicing, and warranty.
Detailed list of features, electro-mechanical effects, and specifications.
Installation checks, control modes, and stand-alone/Master-Slave setup.
Functions of control panel buttons and setting DMX addresses.
Steps for setting DMX address and selecting operational modes.
Diagnostic steps for fixing no light and DMX connectivity problems.
Resolving issues with dead fixtures and DMX communication errors.
To Next Page