Shure 588SA - Accessories

The Model 588SA is high impedance and may be used with any high gain
amplifier with an input of 100,000 ohms or more.
The Model
588SB and 588SBE are low impedance and designed for connection
to a 25 to 200 ohm line or input. This is recommended where long cable lengths
are required or where there are conditions of severe hum disturbance.
To use the
Model
588SB or 588SBE with a high impedance amplifier, use a Shure Model A95A
or A95P Line Matching Transformer. The 588SB has 15 feet of cable, the 588SBE
has 30 feet.
Important: Shure Microphone Cables are selected after exhaustive tests to insure
superior performance in microphones
becausc of low capacities, superior shielding
properties and unusually long life under severe use.
Cables with plastic insulation should not be subjected to excessive soldering-iron
heat. Carefully clean and tin the conductors and the connections to which the con-
ductors are to be soldered. The soldering operation can then be done with a
minimum
of heat, thereby avoiding any possibility of damage to the cable.
Guarantee: Each microphone is guaranteed to be free from electrical and mechanical
defects for a period of one year frcm date of shipment from factory, provided
all
instructions are complied with fully. In case of damage, return the microphone to the
factory for repairs. Our guarantee is voided if the microphone is subjected to accident
or abuse.
FIJKNISHED ACCESSORY
Swivel Adapter ............................................................................................................ A25B
OPTIONAL ACCESSORIES
............
Line Matching Transformer ...... A95A Vibration-Isolation Stand S39B
Line Matching Transformer ...... A95P Quick Disconnect Isolation Unit .... A45
Desk Stands
.................. S38B or S33B Accessory Carrying Case ............ AC56
REPLACEMENT COMPONENTS
Swivel Adapter ............................ A25B
Cable Assembly
90A1504 ..........( for Model 588SA)
Dynamic Cartridge .................. 99C355 C59 ..................( for Model 588SB)
C59E ..............( for Model 588SBE)
(21 4 mm)
OVERALL DIMENSIONS
FIGURE A