1. Turn the Carriage upside down. Cut the zip-ties to remove the 3, 30” Long Handlebars. Lift
up on the Retainer Plate and slide the 3 Handlebars through a side hole of the Carriage,
under the Plate, and out through the corresponding hole on the other side. (Pic 6.1) "
2. Apply the foam Handle Grips from Parts Bag #6. To assist with easing them onto the
Handlebars, lubricate the inside fo the foam Hand Grips with a little hairspray,"
3. Adjust the Handlebars so they appear even on each side of the Carriage. Tighten the three
lock nuts one the Retainer Plate. (Pic 6.3)
To Next Page
Loading...
