SICK DL100 Pro - PROFINET IO High Feature - Safety; Intended Use; Non-Intended Use; Changes and Conversions

Safety
14 © SICK AG • Subject to change without notice • 8021823/126P/2018-12-17
2 Safety
2.1 Intended use
The distance measuring device DL100 Hi is a measuring device consisting
of an opto-electronic sensor and assessment electronics. The measuring
device is only intended for non-contact recording of distances from linearly
movedsystemparts.Distancemeasurementisperformedbyareector.
SICK AG assumes no liability for direct or indirect loss or damage resulting
fromuseoftheproduct.Thisinparticularappliesforanydieringuse
of the product that does not meet the intended purpose and that is not
described or mentioned in this documentation.
2.2 Non-Intended use
The distance measuring device DL100 Pro is no safety component accord-
ing to the EC Machinery Directive (2006/42/EC).
The distance measuring devices must not be used in explosion-hazardous
areas.
All uses not described in intended use are prohibited.
No accessories must be connected or installed that are not expressly
speciedinamountandcharacteristicsandapprovedbySICKAG.
WARNING!
Danger from non-intended use!
Any non-intended use may cause dangerous situations.
Therefore:
• Only use the distance measuring device according to
its intended use.
• All information in the operating instructions must be
strictly complied with.
2.3 Changes and conversions
Changes and conversions at the distance measuring device or the
installation may cause unexpected dangers.
The manufacturer's written approval is required before any technical
changes and expansions of the distance measuring device.