SICK DUSTHUNTER C200 - Replacing the Fuse

109
8011952/YWL2/3-0/2016-08| SICK OPERATING INSTRUCTIONS | DUSTHUNTER C200
Subject to change without notice
TROUBLESHOOTING 6
6.3.3 Replacing the fuse
▸ Control unit MCU must be disconnected from the power supply and potential-free.
▸ Open the door of the MCU, remove and open fuse holder (1).
▸ Replace the defective fuse (2) (see “Miscellaneous”, page 123).
▸ Close and attach the fuse holder.
▸ Close the door and connect power voltage.
Fig. 72: Replacing the fuse



Fuse holder

Fuse