17
8011952/YWL2/3-0/2016-08| SICK OPERATING INSTRUCTIONS | DUSTHUNTER C200
Subject to change without notice
PRODUCT DESCRIPTION 2
2.2 Device components
Measuring system DUSTHUNTER C200 comprises as standard the components:
● Sender/receiver unit DHC-T
● Connection line to connect the sender/receiver unit to the MCU control unit (lengths
5m, 10 m)
● Reflector/scattered light receiver DHC-R
● Connection line to connect the reflector/scattered light receiver to the sender/receiver
unit (lengths 5 m, 10 m, 20 m)
● Flange with tube
● MCU control unit
to control, evaluate and output the data of the sender/receiver unit connected via the
RS485 interface
– With integrated purge air supply, for internal duct pressure -50 ... +2 hPa
– Without purge air supply, therefore additionally required:
● Optional external purge air unit, for internal duct pressure -50 ... +30 hPa
● Purge air hose for supply by MCU control unit-P
Fig. 6: Device components DUSTHUNTER C200
Communication between sender/receiver unit and MCU control unit
As standard, each sender/receiver unit is connected to an MCU control unit via the
connection line.
à
USB 1.1
(RS 232)
Duct
External purge air unit (option)
Power supply
Flange with tube
Connection cable
MCU-P (with purge air supply)
Reflector/scattered light receiver
Purge air hose
à
Sender/receiver unit
MCU-N (without purge air supply)
(option)
Operating and parameter program
SOPAS ET
To Next Page
Loading...
