34
8011952/YWL2/3-0/2016-08| SICKOPERATING INSTRUCTIONS | DUSTHUNTER C200
Subject to change without notice
3 ASSEMBLY AND INSTALLATION
3.1.1 Fitting sender/receiver unit and reflector/scattered light receiver to horizontal lines
To prevent particles flowing into the tube (1) of the scattered light receiver and thus con-
taminating the optics, sender/receiver unit (2) and reflector/scattered light receiver (3)
must be fitted in accordance with Fig. “Fitting of sender/receiver unit and reflector/scat-
tered light receiver to horizontal lines (representation for large active measuring paths)”.
The flanges with tube (4) must be welded on accordingly.
Fig. 16: Fitting of sender/receiver unit and reflector/scattered light receiver to horizontal lines
(representation for large active measuring paths)
Flow direction
Sender/receiver unit
Flange with tube
Reflector/scattered light receiver
Tube
To Next Page
Loading...
