54
8011952/YWL2/3-0/2016-08| SICKOPERATING INSTRUCTIONS | DUSTHUNTER C200
Subject to change without notice
4 START-UP AND PARAMETER SETTINGS
4 Start-up and Parameter Settings
4.1 Basics
4.1.1 General information
Assembly and installation must have been completed according to Section 3 before
starting the work described in the following.
Start-up and parameter setting comprise:
● Setting the measuring system to the duct dimensions
● Fitting and connecting sender/receiver unit and reflector/scattered light receiver,
● Customizing parameter settings according to the respective requirements.
To achieve exact measurement, the measuring system must first be calibrated using a
gravimetric comparison measurement (see “Calibration for dust concentration mea-
surement”, page 76) before being used for continuous measurement of dust content.
To Next Page
Loading...
