SICK DUSTHUNTER C200 - Focussing the Sender Light Beam for Transmission Measurement

60
8011952/YWL2/3-0/2016-08| SICKOPERATING INSTRUCTIONS | DUSTHUNTER C200
Subject to change without notice
4 START-UP AND PARAMETER SETTINGS
4.2.2 Focussing the sender light beam for transmission measurement
▸ Select the “Adjustment / Manual Adjustment / Transmission set reference” directory
and activate the “Permanent LED light” checkbox in the “Adjustment aids” field.
Fig. 36: SOPAS ET menu: DH C200/Adjustment/Manual Adjustment/Transmission set reference
▸ Loosen the knurled screws (see “Sender/receiver unit DHC-T for transmission and scat-
tered light measurement”, page 18), swivel the electronics unit to the side and remove
pivoted shutter cover (1).
Fig. 37: Cover screw for focussing opening

