SICK DUSTHUNTER C200 - Performing Maintenance on the Reflector;Scattered Light Receiver

97
8011952/YWL2/3-0/2016-08| SICK OPERATING INSTRUCTIONS | DUSTHUNTER C200
Subject to change without notice
MAINTENANCE 5
5.2.2 Performing maintenance on the reflector/scattered light receiver
▸ Set the measuring system to “Maintenance” (see “General”, page 92), loosen the
knurled screws and swivel the enclosure to the side.
Maintenance on the scattered light receiver
▸ Push spring (2) to the side, pull bracket (3) to the front and pull scattered light receiver
optics (4) out of the tube.
▸ Close mounting flange (5) with cover (see “Miscellaneous”, page 123).
▸ Open tensioners (8) on the reflector/scattered light receiver for long active measuring
paths and take attachment (10) off.
▸ Carefully clean lens of the scattered light receive optics (7) with an optics cloth.
▸ Check purge air pipe (1), light trap (6) and O-ring (9) for deposits and clean, if required.
Fig. 64: Cleaning the optical interfaces
Scattered light receiver for short active measuring paths
Scattered light receiver for long active measuring paths
 






Purge air pipe

Spring

Bracket

Scattered light receiver optics

Mounting flange

Light trap

Scattered light receiver optics

Tensioner

O-ring
ß
Attachment
 

ß