SICK DUSTHUNTER C200 - Maintenance on the Reflector

98
8011952/YWL2/3-0/2016-08| SICKOPERATING INSTRUCTIONS | DUSTHUNTER C200
Subject to change without notice
5 MAINTENANCE
5.2.3 Maintenance on the reflector
▸ Click the “Mounting” button in menu “DH C200/Adjustment/Manual Adjustment/Motor
control” under position Pivoted shutter reflector see “SOPAS ET menu: DH C200/
Adjustment/Manual Adjustment/Motor control”, page 98).
The pivoted shutter then moves to the cleaning position.
Fig. 65: SOPAS ET menu: DH C200/Adjustment/Manual Adjustment/Motor control
▸ Remove pivoted shutter cover (1), loosen tension spring (6) and take pivoted shutter (2)
off axis (5).
▸ Carefully clean glass pane (4) (both sides) and reflector optics (3) with an optics cloth.
Fig. 66: Cleaning the optical interfaces on the reflector
▸ Lay the toothed belt on the drive axis, push pivoted shutter back onto the axis and
reinstall the tension spring.







Pivoted shutter cover

Pivoted shutter

Reflector optics

Glass pane (both sides)

Axis

Tension spring