Mounting
58 © SICK AG · Germany · All rights reserved · Subject to change without notice 8013796/ZM63/2017-05-09
Operating Instructions
LMS5xx Laser Measurement Sensors
Chapter 5
5.2.9 Mounting with mounting kit 3
Using mounting kit 3 (only in conjunction with mounting kits 1 and 2) you can mount the
LMS5xx such that the scan plane is parallel to the mounting surface. This enables stable
floor mounting or ensures that mounting kit 2 remains precisely adjustable crosswise on
uneven wall surfaces.
Fig. 30: Mounting with mounting kits 1 (part no. 2015623), 2 (part no. 2015624) and 3 (part no.
2015625)
1. Mount mounting kit 3 on the mounting surface.
2. Mount mounting kit 2 on mounting kit 3.
3. Mount mounting kit 1 on mounting kit 2.
4. Mount the LMS5xx on mounting kit 1.
5. Adjust the LMS5xx longitudinally and crosswise.
Important During mounting, please observe the dimensional drawings (see section 10.3.3
“Dimensional drawings, mounting kits” on page 109).
Fixing screws
Mounting kit 1
Mounting kit 3
Threaded holes M8×9
Mounting kit 2
To Next Page
Loading...
