Figure 109: Measurement of the outside
dimension
Figure 110: Measurement of the inside
dimension
►
Select one of the following settings:
•
≥ Object diameter is greater than or equal to n beams:
The output becomes active if the configured number of beams or more were
blocked/made.
•
≤ Object diameter is less than or equal to n beams:
The output becomes active if the configured number of beams or less were
blocked/made.
•
= Object dimension is equal to n beams:
The output becomes active if precisely the configured number of beams was
blocked/made.
A particular number of beams is configured for the outside or inside dimension in the
settings. The object size is shown in the Simulation area and can be changed here using
the mouse.
Figure 111: Setting the outside dimension with the mouse
Output settings
General options for switching outputs see "Advanced settings for the outputs",
page 124.
8 CONFIGURATION WITH SOPAS ET
120
O P E R A T I N G I N S T R U C T I O N S | MLG-2 ProNet 8018748.1Q3I/2024-12-18 | SICK
Subject to change without notice
To Next Page
Loading...
