Figure 132: Summary of the determined transmissions with a positive result
If the difference in transmission between the two materials is not sufficient for
differentiation, the materials can be taught in again using the Back pushbutton
(e.g. check beam selection). If teach-in is not possible, the teach-in process can be
canceled using the Cancel pushbutton.
Figure 133: Summary of the determined transmissions with a negative result
8
CONFIGURATION WITH SOPAS ET
134
O P E R A T I N G I N S T R U C T I O N S | MLG-2 ProNet 8018748.1Q3I/2024-12-18 | SICK
Subject to change without notice
To Next Page
Loading...
